MICREL SWITCH LINUX DRIVER

You need to make sure you strip out all of the stuff that isn’t on your host board. What I have done so far is to download a kernel version 3. This will help to isolate the issue. The linux-davinci tree on our site has a couple of branches. Current descriptor being manipulated. Broadcast storm threshold in percent of transmit rate. The KSZ switch has 2 ports.

Uploader: Mikinos
Date Added: 23 December 2014
File Size: 20.87 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 74500
Price: Free* [*Free Regsitration Required]

Used to determine link. I have managed to get it working on the industrialio board, using the single ethernet port, but I can’t get our board to work with the switch. The defined proc index. Number of MIB counters this hardware has. The chip select line is not being swotch. The defined proc name. If not, would it be simpler to implement this outside of Linux?

micrel.c source code [linux/drivers/net/phy/micrel.c] – Woboq Code Browser

Also, I am no expert on the git system. Pointer to network device. Does this make sense and if so, what can I do to fix it? If I use the mii-tool I get the following response: PHY register to write.

  CARDSCAN 600CX MAC DRIVER

Some ports do not start at 0. I have now set it to PHY 0b and I can now connect to the network. If there is anything else that might help please let me know.

Linux eth0 interface to Micrel KS switch – Welcome to AT91SAM Community Discussions

By clicking “Post Your Answer”, you acknowledge that you have read our updated miceel of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies. Buffer to store the counter. Pointer to PCI device. Hi Charlie, I will try to respond tomorrow with details. Sign up using Email and Password. Destination ports in switch for transmission. Pointer to defined proc definition.

CONFIG_MICREL_KS8995MA: Micrel KS8995MA 5-ports 10/100 managed Ethernet switch

Mike I can’t find what is causing these two error messages. I may ultimately give up and ask you to miccrel me exact instructions but for now I would just like help in solving this problem I have modified the schematic which I have sent to you to correct a problem with the switch hardware config pins, SCONF0-SCONF2.

  MICROBOARD PRINTER DRIVER

Buffer to store the FID. Since I e-mailed Tom, I have learned a good deal more about the various flavours of the kernel and now appreciate more of what features mircel available in the differnt versions.

The address of the switch register. Used for MIB reading. I have missed a few bits out but I suppose that is why we do dev boards. Used for KSZ power management. For each SPI Device: Ethtool driver info data structure. Number of microseconds to delay. Sam Jenkins 1 1.

Mike I am using mii-tool to test that mii interface. Mike I have successfully merged the version 3.

Author: admin